Tag Archives: Tools Studio

Floor Mats

I have a concrete floor in my studio.  I also have flat feet, thus I need really good floor mats in my studio.  Over the years I have tried lots of different options for floor mats.

I tried the cheap ones from Home Depot, etc. When they were not soft enough, I tried stacking up the cheap ones, etc.  I even let someone at a AAW symposium talk me into a really expensive $200 mat. A sucker is born every minute! I hate that mat with a passion!  It will not stay put!  It is always sliding out of position!  Err!!!

A few years ago I decided to change all of my mats to the expensive kitchen mats with holes from Rubber-Cal.  If they are good enough for chiefs who stand on them all day in the kitchen then they are good enough for me.

Continue reading Floor Mats

Lathe Shower Curtains

A “Lathe Curtains” tip in the December 2014 issue of the AAW Journal magazine inspired me. I decided to replace the dirty old painters tarps I used in my studio to control wood shavings with some nice new shower curtains. The new curtains work great and look great.

People say I have never seen an idea, I can’t improve. They may be right. I liked the “use cloth shower curtains” idea but the track, hooks and string shown in the article were to wimp and expensive for me. I decided to make my own long and cheap hooks and hang them from cheap EMT pipe.

Here is how I did it.

Photo: Shower Curtains In Use Shower Curtains In Use

Two white linen shower curtains in use.

My VB36 lathe is behind the curtains.

Note the pile of wood shavings on the floor. The shavings stop where the curtains stop.

The curtains do not go all the way to the floor because it is not necessary. Curtains that drag on the floor get dirty and are a pain to deal with when you want to clean up the shavings. Or, store the curtains out of the way, etc.

The curtains, also do not go all the way to the ceiling because it is not necessary. Throwing the shavings over the curtains while turning is not likely.
Continue reading Lathe Shower Curtains

Ram Board Workbench Cover

I found this new Ram Board stuff at Home Depot a few months ago.  It makes a great workbench cover!

They sell it to protect fancy tile and wood floors in houses while they are building them or remodeling.

Photo: Ram Board Roll Ram Board Roll

Ram board comes in 38 inch by 50 foot rolls. At $30 it is close to my price limit. But, I like it. It is thick and tough. After a couple of days it lays flat.
Continue reading Ram Board Workbench Cover