Klingspor Sandpaper Rolls

I am now using sandpaper rolls from Klingspor for all of my hand sanding. Rather than “Porter Cable Stikit Sandpaper”. I still like the Stikit paper but it is to hard to get.

• I like “Klingspor Abrasives 4.5″x 10 Meter (33′) Pressure Sensitive Adhesive, Paperbacked Roll, xxx Grit, Stearated Aluminum Oxide”. Item # AR330xx. AR33008 for 80 grit, etc. Around $18 per roll on 12/2019.

I purchased several different rolls of stuff from Klingspor. I decided I liked the above the best. It is very similar to the “Porter Cable Stikit Sandpaper” that use to be my favorite.

“Klingspor Abrasives Stearated Silicon Carbide, 4-1/2″x 10 Meter (33′) PSA Roll, 180 Grit, Porter Cable Stickit” is ok. Item #AR136xx. It is cheaper at $14 per roll. But, I don’t like it as much. The paper seems to be a little stiffer.

• I have 80, 120, 180, and 220 grits.

I get it from “Klingspor’s Woodworking Shop”.

I generally do not sand beyond 220 grit. If I do sand beyond 220 then I use 6″ Abralon pads by Mirka.

For more info see my “Great Polyurethane Finishes” handout at http://www.carlford.info/pages/demos_classes/great_poly_finish/Great_Poly_Finish.pdf


• I like to cut up the sandpaper into small sheets in advance and store it in “Large Binder Clips” (aka large paper clips). For more info see “Spindle Turning Sandpaper” section in my “Handy Sandpaper” blog entry.

Notes:
1. I use to use “Porter Cable Stikit Sandpaper”. My old “Stikit Sandpaper” blog entry is now obsolete. It is replaced by this new blog entry.
2. I use Blue Flex disks for all of my power sanding.  See my Blue Flex Sanding Disks blog entry.
3. I have eliminated 150 grit from my sanding. I decided it is to close to 120 grit. Just a waste of time. I sand 80, 120, 180, then 220.

One thought on “Klingspor Sandpaper Rolls”

  1. Carl,
    Per your suggestion a few years ago I purchased a Oneway tool rest. I do like it but I was always annoyed that the handle for the banjo was so loose that I had to use one hand to keep the handle upright in order to slide the banjo around. After several years of frustration I finally took the banjo apart and added a couple of more washers at each end of the banjo. The extra washers added just enough tension to the handle which kept it upright so that it can be moved with one hand. I do not know if you have had that problem but it sure is a relief to be able to slide the banjo about with one hand. Thanks for all your in sights into wood turning.

Leave a Reply

Your email address will not be published. Required fields are marked *